- Pouzdro plastové nebo z nerezové oceli
- Napájení: lithiové baterie
- sWave® bezdrátová technologie
Emergency pull-wire switches are of great importance for the man-machine interface in the area of industrial applications. They are, for example, applied on transport and conveyor systems. After manual actuation, work and functional processes are initiated or switched off.
When the new harmonised European standard EN ISO 13850 concerning functional aspects and design guidelines for emergency-stop devices has come into effect, new requirements must have to be met by these command devices. All emergency pull-wire switches described in this chapter meet the requirements of this standard.
Design and mode of operation
On emergency pull-wire switches the emergency-stop command can be initiated from any point along the pull-wire. They have a positive linkage between the NC contacts and the pull-wire. The emergency pull-wire switches are brought into the operational condition by pre-tensioning the pull-wire, i.e. the NC contacts are then closed and the NO contacts are open. All devices are equipped with wire-breakage detection.
Emergency pull-wire switches without mechanical latching VD or VS do not conform to the EN ISO 13850. It is possible to meet the requirements of this standard by suitable measurement of the circuitry and control technology.
There are devices with one- and two-side actuation. The wire length, the number of contacts and the mounting position, in the middle or on one side of the system, are the main features when selecting an emergency pull-wire switch.
All emergency pull-wire switches bear the CE mark according to the Machinery Directive 2006/42/EC.